JD65-XT Dual Wall Kit

JD65-XT Dual Wall Kit//OVERVIEW

Price: $650.00 SKU: JD65-XT-DWK

The JD65-XT Indoor Cellular Repeater Standard Kit is a high-powered, manual and automatic gain adjustable repeater system that is perfect for providing wireless coverage to a medium sized office, home, small department store, warehouse or underground parking lot. This particular kit is supplied with two wall mount antennas.

A certified test report is included with each repeater that leaves our factory, so you are assured of strict quality controls.

Unlimited Call Capacity
65dB Gain / 13dBm Output Power
FCC Approved. ID: SQXJD65-XT
18 Months Warranty
30 Day Money Back Satisfaction Guarantee
MUTE - Auto Shut Down if oscillation is detected
Medium-Sized Coverage Area (5000 - 6000 Sq ft)
Manual Gain Control Feature (Tx & Rx)
Alarm LED's for Error Detection

Attractive modern design
Wide range of frequencies available
Supports 90-265 Volts / 50-60Hz
AGC: Automatic Gain Control
ALC: Automatic Limit Control
Supports Any Cellular Device (Voice & Data)
Free! - Phone Tech Support
Kit includes 2 Wall Mounted Directional Antennas
Easy to Install

30 Day Money Back Guarantee 18 Months Warranty

ADDITIONAL PRODUCT//INFORMATION

The JD65-XT Dual Wall Cell Phone Repeater Kit is supplied with 2 Wall Mounted Panel Antennas and includes all the peripheral items needed to complete the installation. This kit is designed to provide cellular coverage (voice & data) for a building up to 6,000sq ft. and is perfect for providing wireless coverage inside a medium sized home, office building, restaurant, warehouse, underground parking lot, VIP room, etc.

At the heart of kit is a full duplex 65dB Gain Dual Band repeater that includes carrier grade features like Automatic Gain Control (AGC), Manual Gain Control and MUTE Auto Shut Down to name a few. The standard kit is supplied with a 35ft length of coax that runs from the outdoor antenna to the repeater and 35ft of coax from the repeater to each service antenna. You have the option to customize these coax length as needed. (Minimal additional cost).

Standard Kit Includes:

Yagi Donor Antenna with U Bolts
35ft Length of Coax - Donor
JD65-XT Repeater & Power Supply
N Male / N Male RF Adapter
2-Way Signal Splitter
35ft Length of Coax - (2)
Wall Mount Panel Antennas - (2)
Coax Seal
User Manual
Warranty Card
Free Technical Phone Support

To maintain safe and specific output signal levels, this advanced repeater has built-in AGC and ALC circuits, which can automatically control the gain of the repeater within a 15dB range depending on environmental conditions. In addition, it also has built-in attenuation dip switches that allow you to manually attenuate (fine tune) the repeater's uplink and downlink channels in 1db steps up to 31dB, using color changing LED's as a status indicator.

These Alarm LED's are used as a guide to prevent your installation from re-producing errors due to excessive input signal strength if a pre-amp is used, or from signal oscillation due to the indoor antenna and outdoor antenna being too close to each other, which can have adverse effects on a base station.

A Network Safe / MUTE Feature has also been added to this repeater to protect the cellular network. In short, the repeater will stop transmitting if any errors or signal oscillation is detected within 2 sec of detection. It will cycle for 30 sec then attempt to transmit again. If no adjustment in gain has been made to correct the error within the 30sec MUTE cycle, the system will again shut down after 2 sec. It will run this sequence for a total of 3 times and then shut down completely. Unplugging and powering back up the unit will reset this sequence. The JD65-XT Indoor Repeater is designed to be transparent to the network and will therefore support the same number of calls the BTS in the area can support. It is also compact enough that it can be placed within an electrical closet where space is limited.

Frequency Chart

Model		Uplink	Downlink
JD65-XT850	CELL	824~849 MHz	869~894 MHz
JD65-XT900	GSM900	890~915 MHz	935~960 MHz
JD65-XT18	DCS	1710~1785 MHz	1805~1880 MHz
JD65-XT19	PCS	1850~1910 MHz	1930~1990 MHz
JD65-XT819	CELL/PCS	824~849 MHz	869~894 MHz
JD65-XT819	CELL/PCS	1850~1910 MHz	1930~1990 MHz
JD65-XT918	GSM900/DCS	890~915 MHz	935~960 MHz
JD65-XT918	GSM900/DCS	1710~1785 MHz	1805~1880 MHz
JD65-XT921	GSM900/WCDMA	890~915 MHz	935~960 MHz
JD65-XT921	GSM900/WCDMA	1920~1980 MHz	2110~2170 MHz
JD65-XT19-AWS	PCS/AWS	1850~1910 MHz	1930~1990 MHz
JD65-XT19-AWS	PCS/AWS	1710~1755 MHz	2110~2155 MHz
Filter Bandwidth		GSM & CDMA 25MHz \| PCS 60MHz AWS 45MHz \| LTE 11Mhz
Max total output power		≥13dBm	≥13dBm
Max. Gain		≥60dB	≥60dB
Gain Flatness		CDMA & GSM: ≤5dB, PCS & DCS: ≤8dB AWS ≤6dB, LTE ≤3dB
AGC Range		≥15dB - Auto shut off after 15dB (MUTE)
Maximum Input Power		0dBm
Gain Control Range(MGC)		≥31dB in step of 1dB by Dip Switch
V.S.W.R		≤2
Intermodulation		9KHz~1GHz≤-36dBm	9KHz~1GHz≤-20dBm
Intermodulation		1GHz~12.75GHz≤-30dBm	1GHz~12.75GHz≤-20dBm
Spurious Emission		9KHz~1GHz≤-36dBm 1GHz~12.75GHz≤-30dBm
Spurious Emission Mask		Complies with 3GPP TS 25.106
Modulation Accuracy		Complies with 3GPP TS 25.106
Peak Code Domain Error		Complies with 3GPP TS 25.106
Frequency Stability		≤0.01ppm
ACPR		≥30dB @±5MHz&±10MHz
Noise Figure (@ max gain)		≤5dB
Group Delay		≤4.5 micro Sec
Impedance		50Ω

Mechanical Chart

Power Supply	Input 90- 264 VAC,50 Hz, transformer: 12V/3A
Cooling	Heat Sink Convection Cooling
Power Consumption	< 35W
Operating Temperature	-10°~+50°C (14F ~ 122F)
RF Connector	N Female
Weather Proof	IP40
Dimension	183 x 128 x 46.3 (mm
Weight	< 1 kg / 2.2Lbs
LED Alarm	Standard
Power LED	Power Indicator
ALC LED	Amber @ ALC 1~5dB, Red @ ALC 15-20dB
ALC LED	LED off after 5 seconds red color

Shopping cart

JD65-XT Dual Wall Kit
(5000 - 6000 sq ft) Plus!